Blanke Corner Angles
The BLANKE CORNER ANGLE is the professional retrofit solution when it subsequently emerges that tiled corners and edges need protecting against the effects of significant mechanical loads. The 1.0 mm gauge angle section made of stainless steel – material no. 1.4301 (V2A), matt brushed (240 grain size) is covered with a protective film and supplied with double-sided adhesive tape on the inside surfaces of the legs. The edges are burr-free.
How to apply
Depending on the amount of protection required, you may choose angles 30 mm, 40 mm or 60 mm wide. The corner wall surface must be clean from dust, grease, oil and dry. Remove the protective foil from the glue strips and press the angle onto the corner. Remove the protective foil from the angle surface. Allow 24 hours for maximum adhesion.